USB to TTL converter Micro UART module PL2303HX
6-in-1 USB to Serial Converter SPECIFICATION Chip: CP2102 Compatible with 3.3V/5V voltage input and output Support USB-TTL, USB-232, USB-485, TTL-232, TTL-485, 232-485 six serial conversion Baud Rate: up to 2Mbps Over-current and short circuit protection On-board indicator light indicates working status Support Win8, Win7, WinXp, Win2K, WinCE, Linux, Mac system Size: 3.1cm x 1.8cm / 1.22 x 0.71 inch 6-in-1 USB to Serial Converter Gravity: BLE Sensor Beacon Pack (5 PCS) Gravity: BLE Sensor Beacon Pack (5 PCS) $14.90 Fermion: BLE Sensor Beacon Pack (5PCS) Fermion: BLE Sensor Beacon Pack (5PCS) $16.90 Gravity: I2C HUB Gravity: I2C HUB $1.50 Gravity: Serial Data Logger V2.0 for Arduino Gravity: Serial Data Logger V2.0 for Arduino $11.90 You have chosen:0 Total amount: $0 BUY IT NOW INTRODUCTION Are you troubled by the various level standards and voltages of the serial port? This 6-in-1 USB to Serial Converter is just right for you. Check it out! One module has six functions. This 6-in-1 multifunctional serial converter supports USB-TTL, USB-232, USB-485, TTL-232, TTL-485, and 232-485 converting functions and is 3.3V/5V compatible. It works well with mainstream operating systems such as Windows and Linux. There is a 500mA fuse protection circuit integrated on the module for protecting the device against damage caused by short-circuit or over-current. The on-board indicator light indicates the working status of the device: USB is selected for the COM port (Yellow light) On, data receiving RX (Red light) Flashes, data transmitting TX (Green light) Flashes.
Oview The CP21 12 highly integrated USB to SMBus bridge controller integrates a USB2.0 full-speed functional controller, USB transceiver oscillator and 8 GPI0 pins. All customization and configuration options can be selected through a simple GUI-based configurator. Standard HID devices do not need to develop complex firmware and drivers. CP2112 devices can achieve fast USB connection with minimal development work. Product details ●USB bus power supply 4.0V to 5.25V; Self-powered 3.0V to 3.6V, I/O voltage 1.8V to VDD ●Working environment temperature: -40°C~85°C ●On-chip power-on reset circuit, on-chip voltage regulator: 3.45V output ●Comply with USB specification 2.0 standard; full speed (12Mbps) ●Support USB suspend state through SUSPEND and / SUSPEND pins, integrated 194 bytes-secondary programmable ROM, used to store customizable product information ●512 bytes SMBus data buffer, configurable clock speed device address 7-bit value CP212 slave device address ●Windows, Mac and Linux HID to SMBus library API for rapid application development, open access interface specifications ●8 GPI0 can be configured as input/output and open-drain/push-pull, configurable clock for external devices ●Output 48MHz to 94kHz, switch L ED during reading/writing SMBus ●Module size: 29.5mm*21.3mm, with two M3 mounting holes, one MicroUSB female 0